F150 tranny with overdrive

[Cape Codder]

Hi Carl,
On 7/15/15 you wrote:

Originally Posted by CarlG

When I installed my F150 Transmission, there was absolutely no cutting of the cross member or any part of the chassis at all. It was all bolt in. The wooden floorboard had to have the cut out for the shift lever enlarged a tad since the shift lever was about 1.5 inches aft of where the stock model A was. That's all! No metal was cut or drilled.

If you will I have a few questions. First, did yours come as a kit with everything supplied OR did you buy it piece by piece. As to the drive shaft did that have to be cut and machined? Not knowing any of this installation was a AA Bell Housing used or is all of that included with the F150? Is there anything else that had to be moved or reworked?

Thanks for your time and hope to hear from you!

If you so choose you can send it to me at: [email protected]! My PM's are quite full and don't know how to save what I have which is another issue! HA! HA!

Thanks again,
Joe