![]() |
#1 |
Member
Join Date: Aug 2014
Location: Nampa, Idaho
Posts: 62
|
![]()
I keep reading on here about engine stands such as the ones sold by Berts, or Snyders that bolt to the side of the motor. I have read that is has on the bottom of the mount a flat piece that lays on top of the oil pan rail.
Do the screws with the mount thread into the oil pan screw holes? Does it use two or four screws? Thanks guys Chuck |
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Aug 2014
Location: Nampa, Idaho
Posts: 62
|
![]()
I found most of the information I needed. The screws thread into two of the oil pan bolt holes. Do I have to remove the oil pan?
Last edited by C1Nelson; 11-12-2022 at 03:37 PM. |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,177
|
![]()
need to leave two bolts out for pins to go in
__________________
www.whidbeymodelaclub.com Last edited by Gary WA; 12-30-2023 at 02:37 PM. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,104
|
![]() Sponsored Links (Register now to hide all advertisements)
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|