|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-11-2014, 02:22 AM
|
#9 |
|
Member
Join Date: Oct 2010
Location: Red Beach New Zealand
Posts: 31
|
Re: Model B Crankshaft
daveymc29,
I recently did this. Had the mains ground to standard A size and used Snyders B rods which had nuts that did not contact the sump. Also fitted a modern rear seal which I hope will not leak too much. I expect to run this engine in the next month or so. Cheers, Gavin |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 11:20 PM.