Heater blower motor control switch removal tool.

[flathead4rd]

The bezel on my 50 for the blower motor control switch appears to need a special tool to unscrew it. Has two holes 180 degrees apart. The knob and shaft can be removed for access. Any suggestions?

[mcgarrett]

Here ya go!

https://shoebox-central.com/1949-195...l-removal-tool

[tubman]

I was in a hurry, so I made one by using an appropriately sized 1/4" drive deep socket and grinding it back to make the "teeth" needed to grab the nut. Interestingly, a few year later I needed a similar tool to remove one of the dash nuts on my Corvette; I remembered the one I had made, found it in my toolbox, and it worked for that as well.

[mcgarrett]

Originally Posted by tubman

I was in a hurry, so I made one by using an appropriately sized 1/4" drive deep socket and grinding it back to make the "teeth" needed to grab the nut. Interestingly, a few year later I needed a similar tool to remove one of the dash nuts on my Corvette; I remembered the one I had made, found it in my toolbox, and it worked for that as well.

I did the same thing several years ago. Since this is America, I sacrificed a metric deep socket!

[Tom F OHIO]

Sponsored Links (Register now to hide all advertisements)

Good job mcgarrett for finding the tool for this guy.