Heater blower motor control switch removal tool.
 

The bezel on my 50 for the blower motor control switch appears to need a special tool to unscrew it. Has two holes 180 degrees apart. The knob and shaft can be removed for access. Any suggestions?

Re: Heater blower motor control switch removal tool.
 

Here ya go!

https://shoebox-central.com/1949-195...l-removal-tool

Re: Heater blower motor control switch removal tool.
 

I was in a hurry, so I made one by using an appropriately sized 1/4" drive deep socket and grinding it back to make the "teeth" needed to grab the nut. Interestingly, a few year later I needed a similar tool to remove one of the dash nuts on my Corvette; I remembered the one I had made, found it in my toolbox, and it worked for that as well.

Re: Heater blower motor control switch removal tool.
 

I did the same thing several years ago. Since this is America, I sacrificed a metric deep socket! :D

Re: Heater blower motor control switch removal tool.
 

Good job mcgarrett for finding the tool for this guy.