Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page IDing 40s steels. 4" or 4-1/2" wide? Easy how to.

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 06-07-2025, 11:28 AM   #1
Ken/Alabama
Senior Member
 
Ken/Alabama's Avatar
 
Join Date: May 2010
Location: Alabama
Posts: 3,394
Default Re: IDing 40s steels. 4" or 4-1/2" wide? Easy how to.
Quote:
Originally Posted by GB SISSON View Post
Mart, I like the way you figure things out. Your next assignment is to make a small, portable gauge to tell if a swapmeet crank is 3 3/4" or 4" stroke. I've found exceptions to the clean out hole sizing ID.
I measure across the large counter weight.
Ken/Alabama is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:00 AM.