Rear panhard bar stud

[flathead48]

Has anyone replaced the rear stud for the panhard bar ? If so , the best way to do it .
Thanks, Rick

[blucar]

Originally Posted by flathead48

Has anyone replaced the rear stud for the panhard bar ? If so , the best way to do it .
Thanks, Rick

I would assume you are referring to a '46-48 rear end because vehicles earlier than 46 did not have panhard bars.

[flathead48]

Yes, thank you

[Ken/Alabama]

Doesn’t it have a pin through it to secure it in the housing?

[Angledrive]

Remove pin, heat perch with fire wrench, beat the piss out of the stud.

[flathead48]

Sponsored Links (Register now to hide all advertisements)

Thanks guys, don’t see a pin but will look harder.
Rick

[Ken/Alabama]

Originally Posted by flathead48

Thanks guys, don’t see a pin but will look harder.
Rick

The two I have has pins.

[petehoovie]

Originally Posted by Ken/Alabama

The two I have has pins.

[flathead48]

Probably too much paint on mine, thanks , I will find the pin.
Rick

[blucar]

The pix that Ken/Alabama posted in his reply to this thread clearly shows the shock mount on the diff housing. If the pin and/or mount are not clearly visible on the rear end, you possibly have two problems.. One: you don't have a '46-48 rear end or someone cut the mount off.
The oval headed pin that is shown in the pix is actually a large rivet that will require cutting the riveted head off of in order to drive the large rivet pin out and remove the shock stud.

[flathead48]

Found the pin, thanks guys

Rick