Any other repop tail pans other than ems?

[Kube]

Originally Posted by busmania

For some reason (probably cause I was looking from my phone) I did not notice Dennis carpenter has this part. I ordered it. We'll see. I was pretty impressed with the inner fenders I bought from them so I'm hopeful. But with 2, I should be able to make it happen. Still going to shop around for someone to do it for me so if anyone knows anyone good at rust repair (I have some other work I may farm out too) in Denver or surrounding area, let me know.

Kube, got the headlight floor switch. Thank you!

The issue I had with both Drake and Carpenter pans in the past few years is it seems the curve where the rubber seal attaches (near the bottom) was not fully formed. That made the tool tray opening too wide. And, subsequently, the plate in the middle that the male latch is screwed down to is "short".
If you have the tool tray (wood) covers and they fit before, be certain to try them before any welding.
Also, fit that center piece before welding.