|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-19-2023, 09:59 AM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Garlic Country of CA
Posts: 566
|
Re: 1939 ford shackles
I ream the perch and spring with a 3/4” reamer to be sure the hole is to size and also measure the cartridge with a micrometer. About .001” interference fit is all that will press in the perch in my experience. I machined a cupped tool to press on the body of the shackle cartridge. The spring is much easier to do than the perch.
Good luck. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:14 AM.