|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-19-2020, 07:11 AM
|
#3 |
|
Senior Member
Join Date: Jul 2011
Location: Chester, SC
Posts: 162
|
Re: Distributor Upper Contact Plate
Thanks for the response. I may just run a stamped version and seek to restore this one at a later time. It would appear that points have grown about 1/8 inch over the years too, so the contacts do not meet well. Perhaps in that time I may find some that do.
__________________
Thanks, Mark in SC "We the unwilling, led by the unknowing, are doing the impossible for the ungrateful." -- By society, who is still arguing over who said it. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:26 AM.