carburetor 13/32 deep well socket

[haag1332]

And a couple questions for Mitch.

Were you working on an original gav housing or a repro?

And how was the fit?

I am asking because the two are different, and a lot of thought and experimentation was put into the final design and machining of the socket to allow it to fit properly on both, when they are obviously different.

I have a trick to making these which no one will ever figure out in order to facilitate for the difference, however, it also is what makes these sockets difficult to make and creates a situation where they have to be made one off, individually fitted, and not mass produced.

Bill