carburetor 13/32 deep well socket

[haag1332]

gee whiz mitch, I think I went over the guarantee thing earlier in the thread........like way way back, lol, but now you want a lifetime supply of the "cute little storage capsule"


Seriously, lol, there is no pleasing you guys lol.

Let us know how you make out with your carbs. And on some repro valves the socket may only fit a couple of different ways since the tube on the repros is often off center from the hex.

Bill

[Mitch//pa]

Originally Posted by haag1332

gee whiz mitch, I think I went over the guarantee thing earlier in the thread........like way way back, lol, but now you want a lifetime supply of the "cute little storage capsule"


Seriously, lol, there is no pleasing you guys lol.

Let us know how you make out with your carbs. And on some repro valves the socket may only fit a couple of different ways since the tube on the repros is often off center from the hex.

Bill

Actually I don't even remember what or if there was a guarantee,,was messin... But it won't be needed, as these are high quality..

I tried it out this morning it works as described.. The GAV bottoms out in the socket perfectly leaving the threads exposed, and fits between the GAV and carb housing perfectly..... Nice job