|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Michigan
Posts: 171
|
![]()
I am installing my front wheel cylinders (39-41 Lincoln) and there is no little cone down in the hole for the brake hose taper to seat against??? I read a post on another site that said you can buy the little cone and put it in but both of my local parts stores can't find anything. Can I buy just the cone? What is the proper name for it?
Thanks in advance for your help. Z |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 11,052
|
![]()
Contact these folks. Their website says 32 to 38 but they are extremely knowledgeable.
http://www.earlyv8garage.net/ |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 | |
Senior Member
Join Date: May 2010
Location: Napa,California
Posts: 6,097
|
![]() Quote:
|
|
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: West Michigan
Posts: 1,218
|
![]()
Another knowledgeable source is: Brake Hosees Unlimited. Ask for Nick. Super helpful and very reasonable.
Tom |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Feb 2011
Location: Buchanan, MI
Posts: 677
|
![]()
I don't believe any front wheel cylinder relies on a tapered seat for a seal.
The hose will use a copper washer to make the seal. |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: May 2010
Location: East Hartford, Ct
Posts: 5,898
|
![]() Sponsored Links (Register now to hide all advertisements)
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES |
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Apr 2016
Location: ohio
Posts: 147
|
![]()
I just redid the entire brakes on my 35 with 39 brakes. As mentioned above, the seal on the front cylinders is made with copper washers between the flex line and wheel cylinders. No hard line there to need a seat. I'm not using Lincoln brakes but if you aren't running a hard line into the cylinder I see no reason to need that seat.
|
![]() |
![]() |
![]() |
#8 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 9,082
|
![]()
You are correct.
__________________
"I can explain it for you. However, I can't understand it for you". |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|