|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
06-07-2025, 09:56 AM
|
#7 |
|
Senior Member
Join Date: Jan 2014
Location: Orcas Island Washington
Posts: 5,881
|
Re: IDing 40s steels. 4" or 4-1/2" wide? Easy how to.
Mart, I like the way you figure things out. Your next assignment is to make a small, portable gauge to tell if a swapmeet crank is 3 3/4" or 4" stroke. I've found exceptions to the clean out hole sizing ID.
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1946 Tonner Pickup with 226 H six, 1979 Toyota landcruiser wagon, now wearing 1947 Ford Jailbar sheet metal. 'Rusty ol' floorboards, hot on their feet' (Alan Jackson) |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:21 PM.