|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
09-25-2021, 06:27 PM
|
#1 |
|
Member
Join Date: May 2010
Location: South Australia
Posts: 50
|
8BA Distributor Setup
I have just reassembled the distributor for the 8BA I am rebuilding and performed a trial fit to the timing cover. See the picture attached.
My concern is that the distributor appears to travel too far into the housing and not properly meshing with the drive gear once assembled. Am I observing a problem that doesn't really exist? I would be grateful for any tips on this installation. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:37 AM.