|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Member
Join Date: Dec 2019
Posts: 46
|
![]()
Hello All,
Getting closer to covering original frame for visor. Looking for recommendations for preferred cover/vendor, figuring the collective reading this has covered more visors than I have, which to date is none. Same question applies to adhesive, tips, techniques, etc. Thank you |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 9,360
|
![]() |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Fresno, Ca.
Posts: 3,636
|
![]() |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Dec 2019
Posts: 46
|
![]()
Thanks to those posting thus far. Anyone with info where I can find the corner brackets or pattern for same will be appreciated.
|
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 9,360
|
![]()
I think the picture in this link is what you are looking for, you
could make them from the information in the drawing. http://forums.aa-fords.com/viewtopic...t=visor#p37187 |
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Dec 2019
Posts: 46
|
![]() Sponsored Links (Register now to hide all advertisements)
Perfect! Thank you again for helping out. Every bit makes a difference. |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|