The Ford Barn

skeazle · 07-09-2016, 09:33 PM

So we just finished putting LED lights and turn signals front and rear. What a job that is! I used the Signal Stat 900 on the steering column. The green indicator lights on the switch worked fine and after I loosened the clamp to move it up a little the green lights stopped blinking but the signals are working. What could have happened? I thought about the ground wire but I did not mess with that. I just loosened the top clamp screw so I could move the unit up an inch and then I tightened it back up. Any one have any ideas? Jim

07-09-2016, 09:33 PM	#1
skeazle Senior Member Join Date: Dec 2013 Location: Hershey, Pa. Posts: 102	turn signals So we just finished putting LED lights and turn signals front and rear. What a job that is! I used the Signal Stat 900 on the steering column. The green indicator lights on the switch worked fine and after I loosened the clamp to move it up a little the green lights stopped blinking but the signals are working. What could have happened? I thought about the ground wire but I did not mess with that. I just loosened the top clamp screw so I could move the unit up an inch and then I tightened it back up. Any one have any ideas? Jim