![]() |
#1 |
Member
Join Date: Jul 2010
Location: Tiffin,Ohio
Posts: 36
|
![]()
Looking to build a motor with this crank. My question, can someone tell me the stock measurement of main and rod caps? So many have been filed down. Gonna be a babbit motor. What is a acceptable cap measurement?
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,570
|
![]()
Well, I am assuming your block/rod is clean and all babbitt removed. Bolt a cap on, sans the shims and mic the bore in 90 degree intervals and compare readings.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: Jun 2010
Location: 34.22 N 118.36 W
Posts: 1,068
|
![]() Sponsored Links (Register now to hide all advertisements)
When you have the Babbit done, make sure to take the crank to whoever is doing the job for measurement. John
__________________
As Carroll Smith wrote; All Failures are Human in Origin. |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|