|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: May 2010
Location: Middlebury, CT
Posts: 780
|
![]() Sponsored Links (Register now to hide all advertisements)
I was able to straighten the 4 prongs on my two horn rod assemblies. Removed the wire and now I want to move the good 1939 rod to the 1936 assembly. The rod is bent over at the top of the Handle and Horn Switch (part # 3616). How do I remove the rod without breaking off the bent over portion? Any tricks? Thanks, Bruce |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|