The Ford Barn

mrtexas · 09-14-2010, 11:59 AM

I got my 28 RPU up on the MaxJax today:

So far so good but I had to make a custom post(standard post is on the left, custom on right) for the end of the arms as the Model A frame is way up inside the body as compared to a modern car.

Today is just a test run. Next on my list of projects is installing a new gas tank in the 63 Corvette and then on to fuel injection.

After that, install the rebuilt engine, 39 transmission and Mitchell overdrive in the RPU. Hmm, complete new drive train!

So far I'm very happy with the MaxJax. It takes up a lot less room than a 4 post lift and can be stored away if desired.

09-14-2010, 11:59 AM	#1
mrtexas Senior Member Join Date: May 2010 Location: Sugar Land, TX Posts: 4,420	MaxJax 2 post car lift I got my 28 RPU up on the MaxJax today: So far so good but I had to make a custom post(standard post is on the left, custom on right) for the end of the arms as the Model A frame is way up inside the body as compared to a modern car. Today is just a test run. Next on my list of projects is installing a new gas tank in the 63 Corvette and then on to fuel injection. After that, install the rebuilt engine, 39 transmission and Mitchell overdrive in the RPU. Hmm, complete new drive train! So far I'm very happy with the MaxJax. It takes up a lot less room than a 4 post lift and can be stored away if desired.