The Ford Barn

firechief5215 · 08-13-2013, 07:28 PM

Last week I posted a post on how to rebuild my Spartan horn . I received great feedback . I took it apart today to find the brushes positioned on a angle. After looking further I realized that the plate that holds the brush holders is warped. The horn adjuster is about 1/8-1/4 inch from the plate so it wasn't turned in to far , I think I can replace this plate but I cannot locate one in my books. What would cause this. It doesn't look or smell like it I burnt, looked almost new inside Again Thanks for all your help Billy

08-13-2013, 07:28 PM	#1
firechief5215 Senior Member Join Date: Aug 2012 Location: Houston Delaware Posts: 202	Problem with Horn brushes Last week I posted a post on how to rebuild my Spartan horn . I received great feedback . I took it apart today to find the brushes positioned on a angle. After looking further I realized that the plate that holds the brush holders is warped. The horn adjuster is about 1/8-1/4 inch from the plate so it wasn't turned in to far , I think I can replace this plate but I cannot locate one in my books. What would cause this. It doesn't look or smell like it I burnt, looked almost new inside Again Thanks for all your help Billy