|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-18-2019, 07:25 PM | #1 |
Senior Member
Join Date: Oct 2019
Location: Washington
Posts: 175
|
power disconnect switch
I have been reading how you guys have been installing the disconnect switch, and my question is the shaft you tighten with the brass nuts is not long enough to go through the cross member and floor board. So how have you guys been doing it? I would prefer to have the switch in the car. Thank you Don
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|