Where to attach hoist to pull a flathead

[oldford2]

Originally Posted by bmwillia

I did a search but could not find the info I was looking for, so if it is out there I missed it.

What is the best way to attach an engine hoist to a flathead to remove it?

Should I attach it to the intake where the carb mounts? Should I remove the intake and attach directly to the block?

Thanks in advance!

Brad

Come on Fellas, this not rocket science! Just bolt a short chain in a front and back opposite intake manifold holes. Just did it this morning and no problem. Too many gadgets out there to waste your $$ on.
John