11-05-2014, 10:51 PM
|
#13 |
|
Senior Member
Join Date: May 2010
Location: Spooner, Wisconsin
Posts: 242
|
Re: Removing head
Go to the hardware store and buy four large ax or sledge hammer handle tightening steel wedges. Smooth ridges and sharpen leading edge on grinder. Soak studs, then start tapping them into the gasket area. Two wedges on each side. Just keep going around tapping the wedges in a little. Be patient, keep tapping. It's cheap and has never failed me. .
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:52 PM.