The Ford Barn

loumo · 08-12-2014, 09:59 PM

Mating original ‘29 rear fenders to Brookville 1929 Roadster quarter panels.
I am having a problem getting proper spacing for the weltjng between an original undamaged rear fender and a Brookville quarter panel, I can’t get the space to be narrow enough. The problem is, the mating angles of the Brookville 1/4 panel and the fender are different . When bolted in place the mis-matched angle of the ¼ panel keeps the fender too far away to allow a tight fit of the welting.
Has anyone had the problem and come up with a solution?

08-12-2014, 09:59 PM	#1
loumo Member Join Date: May 2010 Location: cape cod ma Posts: 51	Mating Original Rear Fenders to Brookville Rear Quqrter Panels Mating original ‘29 rear fenders to Brookville 1929 Roadster quarter panels. I am having a problem getting proper spacing for the weltjng between an original undamaged rear fender and a Brookville quarter panel, I can’t get the space to be narrow enough. The problem is, the mating angles of the Brookville 1/4 panel and the fender are different . When bolted in place the mis-matched angle of the ¼ panel keeps the fender too far away to allow a tight fit of the welting. Has anyone had the problem and come up with a solution?