|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-17-2014, 09:50 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: new zealand
Posts: 1,054
|
Re: Fuel Pump push rod bushing
jim is this in your assembled engine if not I used a threaded rod put a small washer and a nut on the top the rod comes thrugh the bottom where the bearing was usesme method as top and tighten up botton nut it will pull the bushing down
__________________
trev,, whats life "TOUGH" whats tough ' LIFE" 
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:10 PM.