The 8th stud

[chl]

I know I read somewhere that if the cable isn't secured by the clamp it will cause the connection to eventually fail at the ignition switch from cable being loose. Just wondering if this is true.

[Bill Goddard]

Originally Posted by chl

I know I read somewhere that if the cable isn't secured by the clamp it will cause the connection to eventually fail at the ignition switch from cable being loose. Just wondering if this is true.

I don't beleive it. The cable is held tight in the switch housing it can't move. Failure was probably insulation of the inner wire wearing through if it was original wire. Bill G