|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-11-2014, 03:03 PM
|
#5 |
|
Member
Join Date: Oct 2010
Location: Red Beach New Zealand
Posts: 31
|
Re: Drive shaft roller bearing shaft OD
I have found the bearing surface pitted and unsuitable for the bearing to run on after the driveshaft has been modified to fit a Leycock overdrive. A pity I did not find this earlier. I can always use 1.096" but would prefer to have the original size confimed. Cheers,
Gavin |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:12 AM.