Manifold machining

[Cape Codder]

I recently had my "heater" exhaust and intake manifold resurfaced. Unfortunately now I cannot install my heater cover because there is not enough room going toward #4 cylinder. It hits the distributor and I don't want to grind the cover. It is an Auto-Lite heater which was in very nice condition other than alignment. When I called him on it he said there was "no way" to mount for resurfacing so he used a belt sander. On a more positive note he told me to find another exhaust manifold heater and he would see what he could do about reimbursement. Only time will tell.