|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Member
Join Date: May 2010
Location: Okeechobee, FL
Posts: 41
|
![]()
I have original rims and was wondering if they will fit the disk brake hubs
that are available through many suppliers? Anything else I should be aware of ?? Thanks Larry |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: St. Michael, Minnesota
Posts: 1,713
|
![]()
I use Granada spindles, hubs, and calipers on a 55 car. I had the new hub/rotors cut about 1/8 inch to fit the 55 steel wheels. These hubs have plenty of meat in them, so it is not a problem taking off a little. They have been on the road for about ten years, driven all over the country.
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Midland Park, NJ
Posts: 4,018
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|