|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Member
Join Date: May 2010
Location: Farmington, Utah
Posts: 77
|
![]()
Can anyone post a picture of where the two wire clips for the wiper are mounted for a 1928 Fordor Leatherback? I understand they are mounted with the bolts that hold the gas tank to the cowl, just not sure if they are mounted above the seam or below. I would also like to see a picture of the clip that hold the same wire to the firewall, above the steering column. Thank you.
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: May 2010
Location: Stayton, Oregon
Posts: 3,806
|
![]()
I just installed these in my 29 coupe. I put them above the seam because the panel goes in the notch and if is below, I don't think it would fit. Anyway, I am not an expert but just a guy that is fixing up my 29 for a driver. I put the one with the notch in the back and the other on the last bolt in the front. Then ran my wiper wire in them. I don't know about the ones on the firewall. I did not use them-would also like to know how to do them.
__________________
Fred Kroon 1929 Std Coupe 1929 Huckster |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
![]() Sponsored Links (Register now to hide all advertisements)
![]() Here they are on my 9-27-28 Phaeton. No wire in mine, since I have the original hand wiper. |
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|