|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-18-2012, 08:13 AM
|
#9 |
|
Senior Member
Join Date: May 2010
Location: Newport, NC
Posts: 199
|
Re: Trouble installing an Accelerator linkage rod spring
This may be a little off topic but what is the best way to rebuild the 1/4 ball on the throttle control assembly? I cannot find a where the suppliers sale replacement ball, like a smaller version of spring perch ball. I could build in up with weld and then go at it with a file and try to get it round. Any suggestions?
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 04:36 PM.