Help needed - Rear bearing/seal/snap ring - 29 Banjo & 37 Wide Five Hub

[Kube]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by Ziggster

Thanks. I think I’ll just likely get a used pair from 3rd Gen Auto, but also see is selling new ones. Looking at the surface edge of the outer cafe ring, it looks like it was CNC punched out. I recognize that pattern from time spent at a company that exclusively used CNC punches. If that’s the case, yes, I would assume they’re not going for a heat treatment process afterwards. With today’s laser cutting machines, I’m very surprised to see that CNC punched out.

I would advise you to not buy any bearings or seals until you have the drums in hand and can measure the diameter required.
I'll also double down on bearings... buy NOS or good - used, NOT repops.