|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-04-2025, 07:39 AM
|
#9 |
|
Senior Member
Join Date: Sep 2014
Location: Mid-Coast Maine
Posts: 3,346
|
Re: JB Weld on a fuel syste, repair
Decades ago I watched the repair of a pin hole leak in a gas tank. The area around the hole was cleaned and flux applied. Then the guy heated up a coin held with pliers and melted a blob of solder to it. He immediately pushed it over the pin hole. The solder held and that was all that was needed to make a permanent repair.
__________________
Archives of historical but relevant older articles: ------------- Hover mouse over the links below and click! ~~~~~~~~~~~~~~~~~--------------- Rumble Seat’s Notes Techno Source for the 1932 thru 1953 Flathead Ford |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:43 AM.