|
|
07-17-2025, 12:29 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Lexington, NC
Posts: 1,016
|
Re: Ratchet nut
Original ratchet nuts are 1 3/8”. An original KR Wilson wrench is 1 7/16” across the flats which fits the original nut.
|
|
|
|
07-17-2025, 01:14 PM
|
#2 | |
|
Senior Member
Join Date: Aug 2012
Location: The Moon
Posts: 999
|
Re: Ratchet nut
Quote:
__________________
The Master Cylinder Enjoying life at the beach in SoCal... Last edited by The Master Cylinder; 07-17-2025 at 02:21 PM. |
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
07-17-2025, 05:51 PM
|
#3 | |
|
Senior Member
Join Date: Jun 2010
Location: Vancouver B.C.
Posts: 137
|
Re: Ratchet nut
Quote:
The 1 7/16" KRW 6-point wrench will probably work but it would be loose, just like my 1 3/8" 12 point wrench will turn the 1 5/16" nut but is a loose fit. I also found a ratchet nut from an old '48 flathead block that I had planned to use - it measures 1-1/8", but the hole is too small for a Model A hand crank so would not likely be found on a rebuilt Model A engine. Happy to report that my new wrench fits and works well. |
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:36 AM.