|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-24-2025, 03:20 PM
|
#7 |
|
Senior Member
Join Date: Jul 2010
Location: Cow Hampshire
Posts: 4,610
|
Re: New aluminum fan blade problem
1-1/2 inch per foot taper reamers exist and are commonly used with ball joint (front end) installation. It creates a nearly "self-locking" taper. I say nearly as unlike a morse taper (5/8" per foot) 1-1/2 inch/foot is "more removable."
Holding your fan perpendicular to the axis of cut will be the challenge. My 20" Flather lathe (1873) comes to mind. Joe K
__________________
Shudda kept the horse. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:30 PM.