|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-22-2024, 01:21 PM
|
#3 |
|
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 2,011
|
Re: Head Gasket Install
I don't use the copper coat sealer. If you decide to use it do so sparingly.
You will have some squeeze out during the process of torqueing the head. Resist the urge to wipe it off. Instead leave it alone for a few days until it dries and then scrape / cut the excess of with a razor blade. If you try to remove it while wet you will have a smeary mess.
__________________
Dave / Lincoln Nebraska |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:13 AM.