Metal Stem Tire Valve question

[TomInCologne]

Originally Posted by fourfords

I am replacing the rubber stems/tubes on my 21" wheeled 1929 Roadster with metal valve stems/tubes. My question is: Does the metal stem require inside hardware to stabilize the stem? I used to have a '30. It had inside hardware for its metal stems. If so, any suggestions on where to locate a vendor?

That's funny, i am just about to prepare the same step... That's why i have all laid out and was able to take a photograph... see the photo.


As i see it, and i am sure somebody will chime in to correct me if necessary, you need the angled piece of metal on the inside, straightening the valve. This is fixed with one off nut, this will be inside the tie. Outside, the valve is 'fixed' to the rim with another nut.