Rear engine/trans mount holes misalignment

[V8COOPMAN]

.

Something else to consider on '33-'34 is the fact that depending on whether 4-cylinder or V8, there are two different length drive shafts & torque tubes. This was taken care of during original assembly by reversing the rear mount....NOTE how the ears for bolts are not centered. So, if you miss the CORRECT REAR holes, you may have a real dilemma on your hands with shaft & t-tube fitment.

You might consider making a pair of front mounts similar to the V8-60 mounts, or like in the drawing BELOW!