|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#21 |
Senior Member
Join Date: Mar 2012
Location: lexington sc
Posts: 456
|
![]()
Thanks for the help been under my car all day finishing up my new clutch install Kevin
|
![]() |
![]() |
![]() |
#22 |
Senior Member
Join Date: Aug 2020
Posts: 235
|
![]()
UPDATE: The pressure plate needed adjusting. Funny thing, though, the adjustment nuts were peened into the slots at the end of each bolt
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#23 |
Senior Member
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,998
|
![]()
You dint have to pull the floor boards, do it from below . Totally unnecessary to pull floorboards unless you have quick lift out units with no screws and no Matt .
|
![]() |
![]() |
![]() |
#24 |
Senior Member
Join Date: Aug 2020
Posts: 235
|
![]()
I had to adjust the pressure plate fingers from the inspection opening on the bell housing
|
![]() |
![]() |
![]() |
#25 | |
Senior Member
Join Date: Aug 2021
Location: alberta canada
Posts: 585
|
![]() Quote:
i bet that took you a while.
__________________
old ugly my old father-in-law told me. "listen close when people tell you how to do stuff they may know something. then do it the way you want." |
|
![]() |
![]() |
![]() |
#26 |
Senior Member
Join Date: Aug 2020
Posts: 235
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|