|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-30-2021, 09:04 PM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Between Seattle & Tacoma
Posts: 2,411
|
Re: Control arm positions
I think without being attached to their devices, they may over extend their reach a bit. On the two tooth, you can rotate a bit for final adjustments. Some rods are not the right length, which causes problems.
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:21 PM.