05-13-2021, 10:29 PM
|
#8
|
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 6,652
|
Re: Mitchell Overdrive
Quote:
Originally Posted by divcoone
Steve, look at drive shaft. You will see a plug. Remove the plug and you will see a pipe plug. Remove that plug and thread a long grease nipple in its place.
|
Actually on the latter units there is a grease fitting on the rear drive shaft also.
Quote:
Originally Posted by Kinner
Steve mentioned to me on oil change in his overdrive and syncro transmission to use 25% STP. I have not changed oil yet but will try it when the time comes.
|
The instruction sheet that came with my Mitchell states "High quality 85/140 weight petroleum based gear oil with a GL5 rating."
|
|
|
Threaded Mode