The Ford Barn

bettlesr · 05-05-2021, 05:08 PM

The picture of the whole setup looks like the one I have in my car. I got mine from Tim Sheridan in Nunca, MI. His number is 616-837-6477 and his prices were good. His setup uses the stock bell housing, and doesn't have to cut the crossmember. I just cut off the upper and lower ears on the cover of the bell on the front of the drive shaft. He will also shorten the driveshaft if you want or you can have it done locally. The only other thing required was to put two washers under the brake cross shaft to lower it slightly. I went with the trans with the 3.01 first gear and middle overdrive ratio. With a bored and reworked engine, it can still pull up hills in OD. Gets a lot quieter when I put it into OD.

05-05-2021, 05:08 PM	#37
bettlesr Senior Member Join Date: Nov 2010 Location: Florham Park, NJ Posts: 396	Re: Tremec T170 Transmission Troubles (this issue may be a puzzle) The picture of the whole setup looks like the one I have in my car. I got mine from Tim Sheridan in Nunca, MI. His number is 616-837-6477 and his prices were good. His setup uses the stock bell housing, and doesn't have to cut the crossmember. I just cut off the upper and lower ears on the cover of the bell on the front of the drive shaft. He will also shorten the driveshaft if you want or you can have it done locally. The only other thing required was to put two washers under the brake cross shaft to lower it slightly. I went with the trans with the 3.01 first gear and middle overdrive ratio. With a bored and reworked engine, it can still pull up hills in OD. Gets a lot quieter when I put it into OD. __________________ 1965 Lotus Elan S2 1930 Model A Sport Coupe