|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-01-2021, 06:26 PM
|
#1 |
|
Member
Join Date: Dec 2012
Posts: 51
|
Filling Pits on Leaf Springs
I have some pitting on my springs that I want to fill. I am thinking that either JB Weld or All-Metal would be good choices since they should hold up. My concern is if they would be flexible enough or if fiberglass filler would be better. Paint,then use some Slip Plate between.
Anyone have any experience that they could share;good/bad or try something else? Thanks Last edited by RonLey; 01-01-2021 at 06:35 PM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:33 AM.