|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
11-27-2020, 12:57 PM
|
#22 |
|
Member
Join Date: Jun 2010
Location: Utica, KY
Posts: 81
|
Re: Offenhauser 400 Heads Value
Thanks Tubman, I was hoping you would respond. I will now make sure to chase all threaded holes and verify they pass. Also will measure chambers and level with a straight edge as advised.
Thanks Bob |
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:08 PM.