Printable diagram for adjusting valve tappets

[alexiskai]

Originally Posted by Synchro909

The two methods are very similar. They both use the pitch of the thread to work out how far to turn the adjustment. IMO, you have just taken it one step further with your diagram while I rely more on "feel".

No worries. As I've learned, there will be at least five comments on any post:

1. This thing is not important
2. This thing is important and you're not going far enough
3. I disagree: [says the same thing using different words]
4. I need help with an unrelated problem
5. I am reopening this thread after nine years to say that I agree with post #3