1940 Brake Bleeding

[mike42]

I did not start in the rear which I will do now. The pedal goes right to the floor and i did have hard brakes before but some of the cylinders were frozen. New cylinders in front only. I have no leaks anywhere. Are you saying to shut off the bleeders each time i fill the master ? I must have filled the master 20 times and nothing yet. I screw the cap on each time, but pedal goes to the floor. I’ll check to see if it needs adjustment next. I’m keeping the master filled the best i can. I do have one drum off right now. Should i reinstall it during this process ?

Thx mike

[51 MERC-CT]

Originally Posted by mike42

I did not start in the rear which I will do now. The pedal goes right to the floor and i did have hard brakes before but some of the cylinders were frozen. New cylinders in front only. I have no leaks anywhere. Are you saying to shut off the bleeders each time i fill the master ? I must have filled the master 20 times and nothing yet. I screw the cap on each time, but pedal goes to the floor. I’ll check to see if it needs adjustment next. I’m keeping the master filled the best i can. I do have one drum off right now. Should i reinstall it during this process ?

Thx mike

You have to shut OFF the bleeder after each time you bleed the line.
That is, slow pump to get fluid in the catch can.
Then close the bleeder and then proceed to next line and do the same.
Fill the master as required.
( I supect that you never closed the bleeders)