|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#1 |
Senior Member
Join Date: Aug 2014
Location: North island Newzealand.
Posts: 272
|
![]()
I bet no one has seen a set of thees, Ford Pilot from 1950, I was wondering about using A8BA parallel valves with them but I am worried about the valve wearing into the face? It was a bit cheaper to use 8ba valves and I still could change the lifters before the motor is finished
|
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Aug 2014
Location: North island Newzealand.
Posts: 272
|
![]()
Has anyone used 8ba valves with cast lifters?
|
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Senior Member
Join Date: May 2010
Location: Charlotte NC KiWi-L100 available here
Posts: 3,002
|
![]()
I have a nos set like yours. I did not know the origin. Thanks
Cheers Tony |
![]() |
![]() |
![]() |
#4 |
BANNED
Join Date: May 2010
Location: Wa.
Posts: 5,423
|
![]() |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: Charlotte NC KiWi-L100 available here
Posts: 3,002
|
![]()
The U.K. Pilot 80g. Vs. US. 43g. Heavy. I don’t believe you would have any problem running 8BA or Chevy valves with these lifters. I purchased these in the USA some years ago.
Cheers Tony |
![]() |
![]() |
![]() |
#6 | ||
Senior Member
Join Date: Aug 2014
Location: North island Newzealand.
Posts: 272
|
![]() Sponsored Links (Register now to hide all advertisements)
Quote:
I am just going to build a nice stock motor for normal use. Quote:
Cool, yes probable better than most reproductions available. |
||
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|