Decided to pull the motor/trans

[100IH]

I'll deal with only one item. The ring gear needs the rounded side of the teeth at the rear as it sits in the chassis. When you remove the starter the bendix goes past the ring gear and comes forward to engage, the rounded end of each tooth aids in engaging. same for the bendix, rounded end is the engage side.

[Licensed to kill]

Originally Posted by 100IH

I'll deal with only one item. The ring gear needs the rounded side of the teeth at the rear as it sits in the chassis. When you remove the starter the bendix goes past the ring gear and comes forward to engage, the rounded end of each tooth aids in engaging. same for the bendix, rounded end is the engage side.

Ah yes, I see that now. I never paid much attention. It's "backwards" from what I am used to. I'll change out the gear. Thanks