The Ford Barn

Hoop · 06-05-2020, 08:31 AM

Thought this was interesting.

https://www.jalopyjournal.com/forum/...eeded.1195035/

35fordtn · 06-05-2020, 08:50 AM

Those are very clearly Dennis carpenter points

Sent from my iPhone using Tapatalk

Will D · 06-05-2020, 01:39 PM

Sponsored Links (Register now to hide all advertisements)

Had a similar issue with some points I got awhile back from standard. They did not align even after bending back to 90...had to add a spacer below the point block, then sand the top of the block to allow brass washer and c-pin to fit back in while allowing the block to pivot freely. Had more time than money...

06-05-2020, 08:31 AM	#1
Hoop Senior Member Join Date: May 2010 Location: Jacksonville FL Posts: 1,137	Helmet Distributor on the HAMB Thought this was interesting. https://www.jalopyjournal.com/forum/...eeded.1195035/ __________________ "Remember that when it comes to intelligence, half of all of us are below average."

06-05-2020, 08:50 AM	#2
35fordtn Senior Member Join Date: Aug 2010 Location: McMinnville, TN Posts: 2,468	Re: Helmet Distributor on the HAMB Those are very clearly Dennis carpenter points Sent from my iPhone using Tapatalk